9 thoughts on “ Good Times Part 2 - Ortin Cam / DP-6 - East vs. West (Vinyl) ”

1. Samulrajas says:

   04.12.2019 at 10:11

   Review: For this edition of Spilo, the 12th release so far, we see 2 of techno music's greatest minds join forces for 'Return Of Techno'. Belgium's Ortin Cam (Tom Macoye) teams up with Spilo label owner Cave (Inge Kjeilen). Tom Macoye has been a solid techno producer since early and so far has over 50 releases under different aliases, the best known of these being Ortin.

   Reply
2. Taukora says:

   08.12.2019 at 00:44

   Good Times is an American sitcom television series that aired for six seasons on CBS, from February 8, , to August 1, Created by Eric Monte and Mike Evans and developed by executive producer Norman Lear, it was television's first African American two-parent family sitcom. Good Times is a spin-off of Maude, which itself is a spin-off of All in the caygiocromchanmangcons.bigsnonabermalinmucelrobilamcess.co of episodes: (list of episodes).

   Reply
3. JoJoran says:

   05.12.2019 at 12:55

   Jul 01,  · As an example, for the cams recommended in Table 1, many of the cam companies recommend new valvesprings, rocker arms and pushrods. (The cams usually come with new lifters, and some come with new.

   Reply
4. Meztilkis says:

   13.12.2019 at 17:36

   We have 5 different iterations of our 3 Bolt (Low Lift) Camshafts for the L, L, and L truck engines – from mild performance increase with stock street manners, to high performance applications. Because these cams cover such a wide spectrum of engines, platforms, and applications – we made sure to offer a camshaft that is sure to meet every need.5/5(7).

   Reply
5. Akim says:

   07.12.2019 at 08:05

   Feb 17,  · (For many street-level cams, the manufacturer grinds the cam 4 degrees advanced by default.) Next measure the cranking compression in the No. 1 cylinder. This can be done even if the engine is not Author: Marlan Davis.

   Reply
6. Brazragore says:

   07.12.2019 at 14:56

   May 12,  · For the next configuration, the cam was stepped up to a Comp XEHL, a very fast-rate lifter design, sporting 17/degrees more intake/exhaust duration atinch lift than the baseline.

   Reply
7. Arashishicage says:

   10.12.2019 at 05:17

   Oct 10,  · Using four lobe profiles on a single cam lets the cam designer provide more duration to the four corner cylinders of a V8 (cylinders 1, 2, 7, and 8 on a Chevrolet or Mopar), compared to the four.

   Reply
8. Gojora says:

   08.12.2019 at 07:50

   Apr 23,  · Opinions on cam choice for Twincam The Board. woods is the way to caygiocromchanmangcons.bigsnonabermalinmucelrobilamcess.co or make really good power with head work and a good fuel map, but if you really think your not gonna go farther later you might be suprised with the andrews 26 or 37 depends on how you ride, of course this could turn into a real nasty o/t thread real fast so ill put it like this: the .

   Reply
9. Nikoshura says:

   10.12.2019 at 22:19

   Jul 25,  · In the page on TR6 performance cams, lobe center angle was calculated because this specification is rarely "revealed" by the cam caygiocromchanmangcons.bigsnonabermalinmucelrobilamcess.co were calculated assuming each lobe of the cam is symmetric. The assumption that a lobe is symmetric is a bad one if the cam is a modern design. Modern cams have more aggressive opening ramps that closing ramps.

   Reply